Working Procedures; Use; Switching On And Off; Emptying The Dust Collector - Parkside PBSD 900 A1 Originalbetriebsanleitung

Fitting the dust collector
♦ Push the dust collector
connection from above.
Dismantling/removing the dust collector
♦ Pull the dust collector
Connecting a dust extraction adapter and
reducer for an external extraction appliance
♦ Push the dust extraction adapter
connection .
♦ Push the reducer
adapter into the adapter fitting
♦ Push the hose from a suitable dust extraction
appliance (e.g. a workshop vacuum cleaner)
onto the reducer
extraction.
Removing the dust extraction adapter and
reducer for an external extraction appliance
♦ Pull off the hose of the dust extraction
appliance.
♦ Remove the reducer
extraction.
♦ Pull the dust extraction adapter
off the connection

Working procedures

A light grinding pressure is sufficient
■ Apply minimal pressure when grinding. The belt
grinder's own weight is sufficient for a good
grinding result. In addition, working this way
helps to reduce the wear on the abrasive belt
and the surface of the workpiece will become
more smooth.
Removal and surface
■ The material removal rate and surface quality
are determined by the belt speed and grain
strength of the abrasive belt
section "Selecting speed and abrasive belt").
PBSD 900 A1
onto the dust collector
off upwards.
onto the
for the dust extraction
.
for external vacuum
for external dust
upwards
.
(see also the
Grinding
■ Place the appliance on the workpiece when
switched on and work at a moderate feed rate.
Guide the grinder in parallel and overlapping
sanding motions over the workpiece. To avoid
unpleasant transverse grinding marks, always
sand in the direction of the grain.
After completing the task, lift the appliance from
the workpiece and then switch it off.
NOTE
► Always hold the appliance firmly with two
hands while working.

Use

Switching on and off
While operating the belt grinder, you can choose
between instantaneous and continuous operation.
Switching to instantaneous operation
♦ Press the ON/OFF switch
Switching off instantaneous operation
♦ Release the ON/OFF switch
Switching to continuous operation
♦ Press the ON/OFF switch
in and then press the lock button
Switching off continuous operation
♦ Press the ON/OFF switch
release it.

Emptying the dust collector

The dust collector should be emptied after every
10 minutes of operation at least.
♦ Pull the dust collector
"Attaching/removing a dust extraction unit")
♦ Shake the dust collector
bin to empty it.
♦ Fit the dust collector
appliance.
.
.
, keep it pressed
.
and then
off (see section
over a rubbish
back onto the
GB │ IE │
19 ■