Before Use; Change Sanding Sheets; Fitting/Changing Accessory Tools (Fig . A) - Parkside PWBS 180 A1 Originalbetriebsanleitung

Before use

WARNING! RISK OF INJURY
► Always remove the plug from the power
socket before working on the appliance .
CAUTION!
► Wear protective gloves when changing
tools. There is a risk of injury if the accessory
tools are touched .
■ Different application tools are available, de-
pending on the material being machined and
the desired degree of surface removal required .
NOTE
► Do not put the appliance down without the
accessory tool fitted (sanding disc, carbide
sanding head, etc .) . The brush ring
bend and be damaged .

Change sanding sheets

The surface of the sanding disc
a velcro fabric so that you can fasten sanding
sheets quickly and easily .
♦ Before attaching a new sanding sheet
move dirt and dust from grinding disc
with a brush .
♦ Position the sanding sheet
edge of the sanding disc
sheet then onto the sanding disc
press it firmly into place . Make sure that the
suction holes on the sanding sheet
grinding disc match up .
♦ To remove the sanding sheet
and pull it off the sanding disc
PWBS 180 A1
may
consists of
, re-
, e .g .
flush against the
; lay the sanding
and
and the
, lift the edge
.
Fitting/changing accessory tools
(Fig . A)
WARNING!
► Press the spindle locking button
when the grinding spindle
Otherwise the appliance may be damaged .
■ Only use carbide sanding heads
with an even sanding surface .
♦ Clean the sanding spindle
be mounted .
♦ Press the spindle locking button
and release the accessory tool .
♦ To fit the accessory tool, place the mounting
flange onto the sanding spindle
♦ Place the desired accessory tool onto the
sanding spindle
♦ Screw the clamping nut
the two-hole assembly spanner
NOTE
► Make sure that the collar of the clamping
nut is facing outwards .
only
is at a standstill .
and all parts to
to clamp
.
.
and tighten it with
.
≤ 3,2 mm
> 3,2 mm
GB │ IE │ NI │ CY │
12
9 ■