Genuine Accessories/Auxiliary Equipment; Information On Saw Blades; Before Initial Use; Charging The Battery (See Fig. A) - Parkside PSTDA 18-Li A1 Originalbetriebsanleitung

■ Secure the workpiece. Use clamps/a vice to
GB
hold the workpiece fi rmly. This is safer than
IE
simply holding it in your hand.
■ Never work on moistened materials or damp
surfaces.
■ Dust may be hazardous! When working for
extended periods on wood and, in particular,
materials that produce dusts that are hazardous
to health, connect the appliance to an appropri-
ate dust extraction device.
■ Wear a dust mask.
■ Ensure there is suffi cient ventilation.
Genuine accessories/auxiliary equip-
ment
■ Only use the accessories and auxiliary
equipment that are specifi ed in the operat-
ing instructions or that are compatible with
the appliance.

Information on saw blades

Parkside basic equipment includes saw blades
principally for use with wood and metal.
▯ 2 saw blades for general wood cutting
▯ 1 saw blade for light metals up to 3 mm
NOTE
► You can use any saw blade provided it is
fi tted with a suitable mounting (single-lug
shank).
Saw blade type
suitable

Before initial use

Charging the battery (see Fig. A)

CAUTION!
► Always unplug the appliance before you
remove the battery pack from or connect the
battery pack to the charger.
6
HINWEIS
►
■
♦
♦
♦
♦
■
■
Attaching/disconnecting the
battery pack to/from the appliance
Inserting the battery pack:
♦
Removing the battery pack:
♦
unsuitable

Checking the battery charge level

♦
♦
Three appliances - three compatible batteries.
Interchangeable!
(see chapter ordering a replacement battery)
Never charge the battery pack when the ambi-
ent temperature is below 10°C or above 40°C.
Connect the battery pack
tery charger (see Fig. A).
Push the mains plug into the mains power
socket. The control LED
The green control LED
charging process is complete and the battery
pack is ready.
Push the battery pack
Never recharge a battery pack again im-
mediately after rapid charging. This could
overcharge the battery pack, thus reducing the
lifespan of the battery and charger.
Switch off the charger for at least 15 minutes
between successive charging sessions.
Also disconnect the power plug from the mains
power socket.
Allow the battery pack
the appliance.
Press the release button
battery pack.
Press the battery charge level button
check the status of the battery (see also main
diagram).
The status/remaining charge will be shown on
the battery display LED
RED/ORANGE/GREEN = maximum charge/
power
RED/ORANGE = medium charge/power
RED = low charge – charge the battery
to the rapid bat-
will light up red.
indicates that the
back into the appliance.
to click into place in
and remove the
to
as follows:
PSTDA 18-Li A1