Installing The Dust Extraction System; Mounting The Adapter For External Extraction; Adjusting The Additional Handle; Working Procedures - Parkside PWBS 180 A1 Originalbetriebsanleitung

Installing the dust extraction system

Dust from materials such as lead-based paints,
some types of wood, minerals and metal can be
harmful to health . Touching or inhaling the dusts
may cause allergic reactions and/or respiratory
illnesses of the user or people in the vicinity .
Certain dusts such as oak or beech dust are con-
sidered carcinogenic, especially in combination
with wood treatment additives (chromate, wood
preservatives) . Materials containing asbestos may
only be worked on by specialists .
■ Always use dust extraction .
■ Operate the power tool either with the dust
bag or a vacuum cleaner (dust class M) .
■ Ensure that your workplace is adequately
ventilated .
■ We recommend you wear a respirator with
a class P2 filter .
■ Avoid kinking the suction hose
Observe the applicable regulations in your country
regarding the materials to be worked .
♦ Plug the inlet side of the suction hose
the extraction nozzle
♦ Now connect the outlet side of the suction hose
to the dust bag
Plug the outlet side of the suction hose
the extraction nozzle of the dust bag
the two push buttons on the suction hose
snap into place .
♦ To dismantle the suction hose
push buttons on the sides of the suction hose
Then pull the suction hose
extraction nozzle
Mounting the adapter for external
extraction
♦ Push the dust extraction adapter
extraction nozzle
♦ Connect an approved dust extraction system .
NOTE
► When sawing wood or other materials
that can create dusts that are hazardous to
health, always connect a suitable, certified
vacuum extractor appliance .
■ 10 │ GB │ IE │ NI │ CY
.
onto
.
.
into
until
, first press the
out of the
.
onto the
.

Adjusting the additional handle

The angle of the additional handle
adjusted to achieve a more favourable working
position for the guide hand in certain applications
(e .g . when grinding close to an edge) .
♦ Loosen the two wing screws
additional handle
position .
♦ Retighten the wing screws

Working procedures

WARNING! RISK OF INJURY
► Always remove the plug from the power
socket before working on the appliance .
► Wait until the appliance has come to a
standstill before putting it down .
The removal rate and the surface quality are de-
termined by the selection of the sanding tool, the
preselected speed level and the contact pressure .
Only sanding tools that are in perfect condition
provide a good sanding performance and protect
the appliance .

Sanding

■
Hold the appliance firmly with both hands
when working and ensure that you have
secure footing.The appliance is guided more
safely with two hands .
♦ Connect your extraction system (internal or
.
external extraction) .
♦ For external suction:
If possible, work with the remote switch-off or
the automatic start/stop function of the vacuum
cleaner . The vacuum cleaner switches on auto-
matically and switches off again after a time
delay in order to remove the remaining dust
from the suction hose .
♦ Switch on the appliance, place it with the entire
sanding surface on the surface you are working
on and move it over the workpiece with moder-
ate pressure .
can be
and tilt the
to the desired working
.
PWBS 180 A1