Herunterladen Inhalt Inhalt Diese Seite drucken

Preparation For Work; Prepare The Surface To Be Painted; Prepare The Paint; Prepare Paint Roller - Parkside PFE 50 A1 Originalbetriebsanleitung

Vorschau ausblenden Andere Handbücher für PFE 50 A1:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 45

Preparation for work

Prepare the surface to be painted

The surface to be painted must be clean, dry
and free of grease. When working indoors, any
surfaces that have not been covered could get
soiled. Therefore, prepare the surrounding areas
thoroughly:
- Cover or tape over floors, furniture, doors and
window frames.
- Place sufficient covering material (plastic sheeting,
cardboard) under the paint bucket and base unit.

Prepare the paint

- Prepare the paint according to the manufacturer's
instructions.
- Stir the paint thoroughly and dilute it if necessary.

Prepare paint roller

Before first use, dampen the paint roller evenly
with clear water and wring out the excess.

Preparable coating materials

Water-based dispersion and latex paints for interior
and exterior walls.

Non-workable coating materials

Solvent-based paints and coatings and materials
containing heavily abrasive components.

Assembly

Press the side locks on the handle
Fit the roller bracket
guide slots (see fig. A).
Release the locks again to fix the roller bracket
in place.
Screw the extension adapter
from below (see fig. B).
To ensure an easy assembling, apply a thin coat
of lubricating grease
(see fig. K + L).
6 
GB
downwards.
, paying attention to the
into the handle
at the marked points.
NOTE
You can also attach standard extensions for
paint rollers to the handle
separately in DIY stores). Push the extension
into the extension adapter
this purpose. Plugging or screw the exten-
sion of this in one of two mounted extension
adapter
.

Mounting/changing the paint roller

First push the inner roller
(see fold out page).
Insert now the cap
(see fold out page).

Controls on the appliance

Main switch
:
Switches the appliance on ("I") and off ("O").
On/off switch paint pump
Press once and release to switch on the pump
to supply paint to the paint roller
To switch off the pump, press the button again.

Operation

Hold the height-adjustable paint bucket attach-
ment
to the side and pull upwards (see fig. C).
Place the paint bucket on the section "X" (see
fig. D) so that the handle of the paint bucket is
between the two brackets.
NOTE
Important: The handle on the paint bucket
must be between the two brackets. Other-
wise, the bucket could tip and spill paint
while being carried.
Push the height-adjustable paint bucket attach-
ment
downwards to fix the paint bucket in
place (see fig. E).
Fix the intake hose
it down to the bottom of the paint bucket (see
fig. F).
Switch on the appliance using the main switch
(can be bought
mounted for
to the paint roller
in the paint roller
:
.
into the bracket and push
PFE 50 A1
.

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis