Attaching/Disconnecting The Battery Pack To/From The Appliance; Checking The Battery Charge Level; Initial Operation; Fitting/Changing The Saw Blade - Parkside PSTDA 20-Li A1 Originalbetriebsanleitung

Attaching/disconnecting the battery
pack to/from the appliance
Inserting the battery pack:
♦ Allow the battery pack
the appliance.
Removing the battery pack:
♦ Press the release button
battery pack.

Checking the battery charge level

♦ Press the battery charge level button
the status of the battery (see also main diagram).
The status will be shown on the battery display
LED as follows:
♦ RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery

Initial operation

Fitting/changing the saw blade

Remove the battery before carrying out any work
on the power tool (e.g. maintenance, changing
tools, etc.) as well as during the transport and
storage of the power tool.
Unintentional activation of the ON/OFF switch
can result in injury.
♦ Press the blade guard together
of the outer catches and pull it off to the front.
♦ Turn the quick-release chuck
in this position.
♦ Push the required saw blade into the quick-
release chuck as far as the stop.
♦ Release the quick-release chuck
returns to its initial position. The saw blade is
now locked.
■ CAUTION! The saw blade teeth must face the
front (see fold-out page)!
PSTDA 20-Li A1
to click into place in
and remove the
to check
at the height
and hold it
so that it

Fitting the blade guard

Fit the blade guard
appliance to a dust extractor.
♦ Fit the blade guard
so that the two outer catches engage in the
recesses in the housing.
♦ Remove the blade guard
a dust extractor or when making mitre cuts.
To do this, press the blade guard together
at the height of the outer catches and pull it
off to the front.

Fitting the rip fence

The rip fence can be fitted on the left or right
of the appliance.
♦ Undo both the clamping screws on the insertion
openings .
♦ Push the rip fence
.
♦ Retighten the two locking screws.

Connecting the sawdust extractor

♦ Push the extraction nozzle
extraction duct until it is secured in place.
Optional, depending on the diameter of the
dust and sawdust extractor.
♦ Attach an approved dust and sawdust extractor
to the extraction nozzle
■ Wear a dust mask.
Supporting the extraction function:
♦ Press the sawdust blower switch
position.

Sawdust blowing function

Switching the sawdust blowing function on:
♦ Press the sawdust blower switch
position.
before you connect the
onto the appliance
for working without
into the insertion openings
into the vacuum
.
to the "O"
to the
GB│ 19■