Technical Specifications; General Power Tool Safety Warnings - Parkside PWBS 180 A1 Originalbetriebsanleitung

Technical specifications

Rated voltage:
Rated power
consumption:
Rated speed:
Rated capacity:
Thread size:
Protection class:
Noise and vibration data:
Noise measurement value determined in accord-
ance with EN 60745 . The A-rated noise level of
the power tool is typically as follows:
Noise emission value:
Sound pressure level: L
Uncertainty:
Sound power level:
Uncertainty:
Wear ear muffs!
Total vibration value:
Surface sanding:
Uncertainty:
PWBS 180 A1
230 V ∼ 50 Hz (AC)
1050 W
n 410−1900 rpm
Ø 180 mm
M14
II / (double insulation)
= 94 dB(A)
PA
K = 3 dB
L = 105 dB(A)
WA
K = 3 dB
a = 16 .4 m/s
2
h, AG
K = 1 .5 m/s
2
NOTE
► The vibration level specified in these instruc-
tions has been measured in accordance with
a standardised measuring procedure and
can be used for appliance comparisons . The
specified vibration emission value can also be
used to make an initial exposure estimate .
WARNING!
► The vibration level varies depending on the
use of the power tool and may be higher
than the value specified in these instructions
in some cases . Regular use of the power tool
in this way may cause the user to underesti-
mate the vibration . Try to keep the vibration
loads as low as possible . Measures to reduce
the vibration load are, e .g . wearing gloves
and limiting the working time . Wherein all
states of operation must be included (e .g .
times when the power tool is switched off and
times where the power tool is switched on but
running without load) .
General power tool
safety warnings
WARNING!
► Read all safety warnings and all instructions .
Failure to follow the warnings and instructions
may result in electric shock, fire and/or
serious injury .
Save all warnings and instructions for future
reference.
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-
operated (cordless) power tool .
GB │ IE │ NI │ CY │ 3 ■