Functional Test; Operating - Moretti Forni iP 33 Bedienungsanleitung

3.3 Functional test

After inserting the plug the machine is ready for use.
IGNITION
Rotate the knob of the switch E (PICT. 4-5) in position 1, the machine waits. Set the timer D at 10
seconds and regulate the knobs A-B (PICT. 5) at ISO° C. The devices A1-B1-E1 will be lighted.

OPERATING

Push the buttons C at the same time to activate the up/down cycle of the lower plate.
Note: If the lower plate goes down of about 20 mm and immediatly goes up stops in the position
(while the machine is on) the following procedure is necessary both of the ignition and for each
time the feeding tap is changed.
· Turning the knob of the switch E in position 0 turn of the machine.
· Take the plug out the main switch.
· On the switch reverse the position of the two phases (example: L1 with L2 and viceversa).
Operate once more the machine and check if the distance between the plates is within 0 and 1 mm.
TO STOP/ TO TURN OFF
To turn off completely the machine, turn the knob of the switch E in position 0, the machine
stops and the lights gradually fade. Start the machine without using it, let it run for 15 minutes
and verify that the disks are being heated and make sure it is functioning perfectly.
iP 33-45 Operating manual
30