diversey Taski swingo XP Original Bedienungsanleitung Seite 35

Tank position for battery maintenance.
Closing battery compartment
• Stand next to the machine, hold the tank at the
front, under and behind the back of the tank.
• Place the tank on the tank support.
• Hold the tank firmly, not at the side but at the
indentation at the front, and then push the tank
support inwards.
Now lower the tank until it locates into place.
Attaching tools
• Switch the machine off using the keyswitch and remove the key.
Check:
• that the brush has not gone below the red mark or the bristles are not
shorter then 15 mm, or that no foreign bodies are present.
• the pad for wear before using.
Working with worn out, damaged and or wrong tools, could result
in possible damage to floors or their protective layers.
• Press the tool upwards and push it in until it
latches into position.
click
Attach squeegee
• Switch the machine off.
• Lay the squeegee under the squeegee holder.
• Position the squeegee so that the squegee
holder is under the towing strap.
• Press the mounting pedal down until the
squeegee locks in, and then release pressure.
The squeegee lifts up from the floor when the
mounting tool is released.
• Plug the two suction hoses into the squeegee.
FIll the Flex tank
• Switch the machine off using the keyswitch and remove the key.
• Reach into the opening between the tank cover
and the tank (with the palm of your hand
upwards). Pull the locking bracket forward and
open the tank cover.
• Check that the sieve and the Flex tank are installed.
• Remove the dosing cup from the Flex tank.
Caution:
Maximum permissible water temperature 60 °C/140 °F.
• Fill the Flex tank with water.
The upper red mark indicates the maximum
permissible filling level.
The lower red mark indicates the half-full level.
Dosage:
Caution:
When handling chemical products, always wera gloves,
protective goggles and the corresponding (protective) work
clothing! (in accordance with the information propvided by the
detergent manufacturer)
Please use the recommended TASKI chemical products only.
Caution:
Using other chemicals (e.g. chemicals containing solvents,
chlorine, hydrochloric acid and hydrofluoric acid) can damage or
destroy the machine.
Dosing examples (The concentration is product dependent)
Instructions on the product's
packaging
0.5% 50ml to 10l water
1.0% 100ml to 10l
water
• Add the measured product to the water in the Flex tank using the dosing
cup.
• Insert the suction filter at the lowest point of the Flex tank.
• Place the dosing aid in the tank and close the tank lid.
By exerting slight pressure onto the front of the lid, you can click it into the
latch.
Caution:
When closing the tank cover, do not hold onto the locking bracket.
You could trap your finger!
Tank capacity The volume per
tank filling
105l 525ml = 0.525l
105l 1050ml = 1.05l
33