Hazards During Operation - Parkside 6.3 A2 Bedienungs- Und Sicherheitshinweise

Ensure that the workpiece is
„
fixed securely in place.
Ensure that the parting disc is
„
clamped securely to the pneu-
matic angle grinder.
Check that the parting disc's
„
maximum operating speed
(in rpm) is equal to or greater
than the spindle's rated speed.
Brushes should not be fitted to
machines when their speeds
are greater than the maximum
values approved for brushes.
Make sure that the protective
„
cowl is fitted, is in good work-
ing condition, has been se-
cured properly, and is inspect-
ed at regular intervals.
Check regularly that the pneu-
„
matic angle grinder's speed is
not greater than that specified
on the machine. These speed
tests must be conducted with-
out attached parting disc and
in accordance with the manu-
facturer's instructions.
Check that the clamping flang-
„
es are used in accordance
with the manufacturer's spec-
ifications and that they are
plane and in good working
condition, e.g. uncracked and
unfractured.
Check that there is no damage
„
or wear on the spindle and
spindle thread.
Safety instructions for pneumatic tools
Check that there can be no
„
hazards posed by sparks and
debris generated during use.
The pneumatic angle grinder
„
must be disconnected from its
power supply before mainte-
nance and before the parting
disc is replaced.
TRAPPING HAZARDS
There is a risk of strangulation,
„
scalping, and/or other cutting
injury when loose clothing,
jewellery, necklaces, hair, or
gloves are not kept away from
the machine and its accesso-
ries.
HAZARDS DURING
OPERATION
Avoid contact with the rotating
„
spindle and attached parting
disc to prevent cutting injuries
to hands and other parts of the
body.
Using the machine may ex-
„
pose the operating personnel's
hands to hazards such as e.g.
cuts, scrapes, and heat. Wear
suitable gloves to protect the
hands.
The operating and the mainte-
„
nance personnel must be
physically able to handle the
machine's position, size, mass,
and power output.
GB/CY 9