Hazards During Operation - Parkside PDSS 16 A1 Originalbetriebsanleitung

Hazards during operation

■ Avoid contact with the rotating shaft and the accessory tool to
prevent cuts on your hands and other body parts.
■ When using the machine, the operator's hands can be subject to
hazards such as cuts, grazing and heat. Wear suitable gloves to
protect your hands.
■ The operator and maintenance personnel must be physically ca-
pable of handling the size, weight and power of the compressed
air tool.
■ Hold the compressed air tool correctly:
be ready to counteract any normal or sudden movements –
keep both hands ready.
■ Keep proper footing and balance at all times.
■ Prevent unintentional starting. If the air supply is interrupted,
switch off the compressed air tool on the On/Off switch.
■ Use only the lubricants recommended by the manufacturer.
■ Use personal protective equipment. Always wear eye protec-
tion. Wearing personal protective equipment such as protective
gloves, non-slip safety shoes or hearing protection, depending on
the type and use of the power tool reduces the risk of personal
injuries and it is recommended.
■ The permissible speed of the accessory tool used must be at least
as high as the maximum speed specified for the compressed air
tool. Accessories that rotate faster than the permissible rate can
break and throw pieces into the air.
■ Wear a safety helmet for overhead work.
■ The tool will run on after the compressed air tool has been
switched off.
■ Ensure that no hazard is caused by sparks created during use.
Explosive or flammable dusts can be generated when processing
PDSS 16 A1
GB │ IE │
37 ■