Troubleshooting - Scheppach HBS30x Originalbetriebsanleitung

15. Troubleshooting

Fault Possible cause
Motor does not work Motor, cable or plug defective, fuses burnt
Housing cover open (limit switch)
The motor starts up Voltage too low, coils damaged, capacitor
slowly and does not burnt
reach operating
speed.
Motor makes exces- Coils damaged, motor defective
sive noise
The motor does not Circuits in the network are overloaded
reach its full power. (lamps other motors, etc.)
Motor overheats eas- Overloading of the motor, insufficient cool-
ily. ing of the motor
Saw cut is rough or Saw blade dull, tooth shape not appropriate
wavy for the material thickness
Workpiece pulls away Excessive cutting pressure and/or saw
and/or splinters blade not suitable for use
Saw blade is not run- a) Guide has been wrongly set
ning straight
b) Wrong saw blade
Burn marks appear on a) Blunt saw blade
the wood during the b) Wrong saw blade
cutting work
Saw blade jams during a) Blunt saw blade
cutting work b) Deposits on the saw blade
c) Guide has been set poorly
32 GB
Remedy
Arrange for inspection of the machine by a
specialist. Never repair the motor yourself.
Danger!
Check fuses and replace as necessary
Close housing cover exactly
Contact the utility provider to check the voltage.
Arrange for inspection of the motor by a special-
ist.
Arrange for replacement of the capacitor by a
specialist
Arrange for inspection of the motor by a special-
ist
Do not use any other equipment or motors on
the same circuit
Avoid overloading the motor while cutting,
remove dust from the motor in order to ensure
optimal cooling of the motor
Resharpen saw blade and/or use suitable saw
blade
Insert suitable saw blade
a) Set the saw blade guide according to the
operating instructions
b) Select a saw blade according to the operating
instructions
a) Change the saw blade
b) Select a saw blade according to the operating
instructions
a) Change the saw blade
b) Clean the saw blade
c) Set the saw blade guide according to the
operating instructions