Cleaning And Servicing; Cleaning; Storage; Waste Disposal And Environmental Protection - Parkside PTK 2000 E3 Originalbetriebsanleitung

GB IE
6. Secure the power tool against tilting and sliding.
7. Never use the protective devices for handling or transport.

Cleaning and Servicing

Remove the mains plug before carrying out any adjust-
ments, maintenance or repair work.
You should have any repair and maintenance work that is
not described in these instructions carried out by our Ser-
vice Centre. Only use original parts.
Perform the following cleaning and maintenance work regularly.
This guarantees reliable use for a long time.

Cleaning

The device must not be sprayed with water or
placed in water. Otherwise there is a risk of
electric shock.
• Keep the safety devices, air vents and motor housing as free
of dust and dirt as possible. Wipe the device off with a clean
cloth or blow it out with compressed air at a low pressure.
• We recommend that you clean the device immediately after
every use.
• Do not use any detergents or solvents; these might attack the
plastic parts of the device.
• Oil the moving parts once a month in order to extend the tool
life. Do not oil the motor.

Storage

• Store the appliance in a dry place well out of reach of
children.
Waste disposal and environmental
protection
Take the batteries out of the device and recycle the device, bat-
teries, accessories and packaging in an environmentally friendly
manner.
Electrical machines do not belong with domestic waste.
In accordance with the EU directive 2012/19/EU on waste elec-
trical and electronic equipment and its implementation in natio-
nal law, used electrical devices must be collected separately for
disposal and recycled in an environmentally sound manner.
Alternative to returning the device:
If not sending back the electrical device, its owner is instead
obliged to cooperate with its proper recycling in the event of a
change in ownership. The old device can be handed over to a
collection facility which will dispose of it in compliance with the
national circular economy and waste legislation. This does not
affect accessories enclosed with the old devices or tools without
any electrical components.
32
• Dispose of the batteries according to local standards. Hand
in the batteries at a used battery collection point where they
are recycled in an environmentally friendly manner. For more
information, please contact your local waste management
provider or our service centre.
• Defective units returned to us will be disposed of for free.

Spare parts/Accessories

Spare parts and accessories can be obtained at
www.grizzly-service.eu
If you do not have internet access, please contact the Service
Centre via telephone (see "Service-Center" page 33). Please
have the order number mentioned below ready.
(6) Parallel stop, complete ....................... Order-No. 91105446
(40) Transverse stop. .............................. Order-No. 91105445
(2) Blade guard, complete ....................... Order-No. 91104563
(17) Table length extender ....................... Order-No. 91105436
(5) Table insert ....................................... Order-No. 91105443
(7) Table width extender (right) ................ Order-No. 91105438
(7) Table width extender (left) ................... Order-No. 91105437
(35) Laser .............................................. Order-No. 91104558
(3) Riving knife ....................................... Order-No. 91104559
(11) Handwheel, complete ....................... Order-No. 91104560
(19) Push stick ........................................ Order-No. 91104950
(14) On/off switch, complete ................... Order-No. 91104952
(24) Stand brackets (both sides) ............... Order-No. 91105444
(23) Rubber feet ..................................... Order-No. 91105439
(4) Saw blade 24 Teeth .......................... Order-No. 13800400
(4) Saw blade 48 Teeth ........................... Order-No. 13800401
(15) Collection bag ................................. Order-No. 91105435