10. Servicing, Maintenance, Troubleshooting; Maintenance - Orbitalum GF 4 series Originalbetriebsanleitung Und Ersatzteilliste

enGLISH
Servicing, maintenance, troubleshooting

10. SeRVIcInG, MAInTenAnce, TROUBLeSHOOTInG

nOTe!
DAnGeR!
DAnGeR!
10.1

Maintenance

InTeRVAL
Before starting work
Every time the cutter is cleaned
Every time the tool is changed
Every week
98
ORBITALUM TOOLS GmbH D-78224 Singen www.orbitalum.com
Some of the work mentioned depends a great deal on the use and on the ambient conditions.
The cycles specified are minimum specifications. In individual cases, differing maintenance
cycles are possible. To ensure the safety of the machine, perform maintenance annually
using an authorized service center with VDE testing. If the machine does not function as
previously described, the machine must also be sent into an authorized service center.
Danger of death by electric shock!
Non-observance could result in death or serious injury.
X At the end of each working cycle, before transportation, changing tools, cleaning and
performing any maintenance, adjustment or repair work, switch off the machine, wait
until the machine/tool stops running and pull the mains plug.
Risk of electric shock due to poor electrics!
Fatal electric shock.
X At the end of each working cycle, before transportation, changing tools, cleaning and
performing any maintenance, adjustment or repair work, switch off the machine, wait
until the machine/tool stops running and pull the mains plug.
X Repair and maintenance work on the electrical equipment may only be carried out by a
qualified electrician.
AcTIVITy
X Remove chips and dirt from the saw blade.
X Keep the vent holes free from chips.
X Check the oil level of the gear and top up if
necessary (see chap. 10.2, p. 99).
X Make sure that the felt ring (1) is on the locking
sleeve, replace if necessary. Felt ring for GF 4,
GF 6, RA 8, RA 12: Code 790 046 168.
X Do not use compressed air to clean the area
at the end of the shaft marked with an arrow as
the rotary shaft seal may otherwise be damaged
by chips.
X Use a cloth or brush to clean the end of the shaft.
X Clean and oil:
• The spindle of the hand wheel (1)
• The sliding block (2)
• The guide bush (3)
• Vice tracks (4)
• Vice spindle (5)
GF 4, GF 6, RA 8, RA 12 (AVM/MVM)
[REV. 20190510] OC_GF_RA_BA_790142765_00__INH-02_EN
1
1
2
3
4
5