Information And Safety Instructions For The Responsible Body; Requirements For The Responsible Body; Using The Machine; Proper Use - Orbitalum GF 4 series Originalbetriebsanleitung Und Ersatzteilliste

enGLISH

Information and safety instructions for the responsible body

2. InFORMATIOn AnD SAFeTy InSTRUcTIOnS FOR
THe ReSPOnSIBLe BODy
2.1

Requirements for the responsible body

Workshop/outdoor/field application: The responsible body is responsible for safety in the danger zone around the
machine, and should allow only qualified personnel to enter the zone or operate the machine in the danger zone.
employee safety: The safety regulations described in chap. 2 must be observed and work must be carried out with safety in
mind using the prescribed protective equipment.
2.2

Using the machine

2.2.1

Proper use

• The machine should be exclusively used for the cutting and beveling of materials and tube
dimensions as specified in chap. 4.3.2, page 71.
• The machines must only be operated using the voltage levels specified on the drive identification
plate and in the "technical data" (see chap. 5, p. 72).
• Only use the motor GF07 (Code 790 142 460 and 790 142 463) as the drive for GF 4 and GF 6.
Motor GF09 (Code 790 046 460 and 790 046 463) for RA 8 and RA 12.
• The drive motor may only be used in connection with the machine.
• The automatic and manual feed module AVM/MVM may only be operated in combination with
the Orbitalum Tools pipe cutter GF 4, GF 6, RA 8 or RA 12.
• The machine may only be used on pipes and containers that are empty, unpressurized, do not
have explosive atmospheres and are not contaminated.
Proper use also includes the following:
• observing all safety instructions and warning messages included in these operating instructions
• carrying out all inspection and maintenance work
• sole use in the original condition with original accessories, spare parts and materials
• processing only materials set out in the operating instructions.
2.2.2

Improper use

• A use other than that defined under "proper use" or a use that goes beyond this or the specified
• constraints shall be considered improper use due to the potential risks involved.
• The responsible body shall be solely responsible for damages that arise through improper use
and the manufacturer shall assume no liability whatsoever.
• No tools should be used that have not been authorized by the manufacturer for this machine.
• The removal of safety equipment is not permitted.
• Do not misuse the machine.
• The machine is not intended for use by private consumers.
• The technical values defined for normal operation must not be exceeded.
• Do not use the machine as a drive for applications other than those listed under proper use
(chap. 2.2.1).
56
ORBITALUM TOOLS GmbH D-78224 Singen www.orbitalum.com
GF 4, GF 6, RA 8, RA 12 (AVM/MVM)
[REV. 20190510] OC_GF_RA_BA_790142765_00__INH-02_EN