Adjusting The Bevel Cutter - Orbitalum GF 4 series Originalbetriebsanleitung Und Ersatzteilliste

enGLISH
Set-up and assembly
3. Use the handle to turn the motor upwards for about 30° until the saw blade is in cutting position.
4. Turn the hand wheel (1) until the teeth of the additional cutter (2) cover the wall thickness of the pipe.
5. If desired, perform a test cut (Cutting and beveling the pipe, see chap. 9.1.5, page 91 for machines with AVM, chap. 9.2.4, page
94 for machines with MVM and chap. 9.3.4, page 97 for working without AVM/MVM), check the cut and bevel and readjust the
hand wheel (1) if necessary.
6. Turn the motor back to its home position.
When working with the AVM: Hold down the STOP button (6), and pivot the motor back into the normal position.
30°
nOTe!
8.6.3

Adjusting the bevel cutter

1. Turn the slide with the bevel cutter (2) all the way down using the hand wheel (1).
2. Insert the pipe so that it almost reaches the bevel cutter (2). The pipe must not project over the cutter. Tighten using the multifunc-
tional wrench (3).
84
ORBITALUM TOOLS GmbH D-78224 Singen www.orbitalum.com
1
3
2
Scale of the hand wheel: a readjustment by one graduation mark results in a radial feed or
bevel alteration of 0.1 mm (0.004"), for the GF 6 of 0.2 mm (0.008").
1
GF 4, GF 6, RA 8, RA 12 (AVM/MVM)
6
4
2
[REV. 20190510] OC_GF_RA_BA_790142765_00__INH-02_EN