Cutting The Pipe Manually And Beveling It Simultaneously - Orbitalum GF 4 series Originalbetriebsanleitung Und Ersatzteilliste

GF 4, GF 6, RA 8, RA 12 (AVM/MVM)
nOTe!
nOTe!
9.3.4

cutting the pipe manually and beveling it simultaneously

• Pipes with a wall thickness of up to 7 mm (0.276") can be simultaneously cut and beveled.
• If using an additional cutter, the cutter motor has to be turned around the pipe more slowly than during normal cutting, as
two tools are being used at the same time. The procedure is the same as described in chap. 9.3.2, page 95.
nOTe!
[REV. 20190510] OC_GF_RA_BA_790142765_00__INH-02_EN
Use only saw blade lubricant (no oils) from Orbitalum Tools (e.g. GF LUB or GF TOP).
Keep the machine clean. Always remove residue from lubricant from the machine.
For continuous operation: After beveling, loosen the hexagon nut on the bevel cutter to avoid
damage caused by tension.
1
• If necessary, lubricate the saw blade and the additional cutter again during work.
• For continuous operation: After cutting loosen the hexagon nut on the saw blade to
avoid damage caused by tension.
• The evenness of the bevel height depends on the roundness of the pipe.
Operation
7. Switch the motor on.
8. Carefully turn the motor clockwise using the handle (1) until
the pipe wall has been pierced through.
9. Continue turning steadily until the pipe has been beveled
completely.
10. Switch off the machine and wait until the machine/tool
stops running.
Orbitalum Tools GmbH D-78224 Singen www.orbitalum.com
enGLISH
97