Commissioning And Operation; Making And Checking Presettings; Set The Bus Coupler Address(Es) - Aventics AS-i Betriebsanleitung

AS-i 4DI/4DO-AUX
and AS-i 4DO-AUX
addressing
AVENTICS | AS-i | R499050017–BDL–001–AE
7

Commissioning and operation

7.1

Making and checking presettings

The following presettings need to be made and observed:

Set the bus coupler address(es)

W
Observe Valve address assignment
W
Observe Input/sensor address assignment
W
7.1.1 Set the bus coupler address(es)
The following points must be taken into consideration when
assigning the address(es):
It is not possible to assign addresses twice in the AS-i bus.
W
The bus couplers always have the A and B address in AS-i
W
protocol 2.1.
How to set the bus address(es):
1. Connect the AS-i bus connection (PWR) to an AS-i
addressing device via the addressing cable (see „Spare
parts and accessories" on page 81).
2. Assign the address in the areas 1 to 31.
3. Document the address in the label area of the module and,
if necessary, the cable socket label.
Default setting for all participants: address 0.
Table 8: Codes for the bus couplers
AS-i... I/O code
8DI/8DO-AUX 7
4DI/4DO-AUX 7
8DO-AUX 8
4DO-AUX 8
Commissioning and operation
ID code ID2 code
F E
F E
F E
F E
69