Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
PAR. DESCRIPTION
H25 Enable buzzer (only if buzzer is present). n = not enabled; y = enabled
UP key configuration.
H31
0 = disabled; 1 = SOFT START; 2 = Setpoint Offset; 3 = Cyclic Controller;
(!)
4 = AUX; 5 = STAND-BY; 6-7-8 = Not used; 9 = hot/cold mode.
H32 DOWN key configuration. Same as "H31".
H34 AUX key configuration. Same as "H31".
reL Firmware release. Device version. Reserved: read-only parameter.
tAb tAble of parameters. Reserved: read-only parameter
PA2** Access to level 2 parameters (INSTALLER). See Password and Programming Menu sections.
UNICARD / COPY CARD (folder FPr)
UpLoad. Transfer of programming parameters from instrument to Unicard/
UL
Copy Card
downLoad. Transfer of programming parameters from Unicard/Copy Card to
dL
instrument
Format. Cancels all data entered in the Unicard/Copy Card.
IMPORTANT: If parameter "Fr" (Unicard/Copy Card formatting) is used, the data
Fr
entered in the card will be permanently lost. This operation cannot be reversed.
The controller must be switched off and then on again after the operation with the
Unicard/Copy Card.
NOTES: 1) PA2** is visible (if enabled) at Level1 in folder CnF and can be set at Level2 in folder "diSP" with parameter PS2.
2) If the value box is blank or coloured black this means that the parameter is not available in this model
3) If one or more parameters marked with (!) are edited, the controller MUST be switched off after the modification and then
switched back on.
4) It is strongly recommended that you switch the device off and on again each time the parameter configuration is changed, in
order to prevent malfunctioning of the configuration and/or ongoing timings.
U.M.
RANGE
MODEL
flag
n/y
ALL
ALL
num
0 ... 9
ALL
num
0 ... 9
ALL
num
0 ... 9
/
/
ALL
ALL
/
/
ALL
/
/
ALL
/
/
ALL
/
/
DR4020 DR4022
n
n
0
0
0
0
0
0
/
/
/
/
/
/
/
/
/
/
Werbung
Inhaltsverzeichnis
