"Installer" Menu - Eliwell DR4000 series Handbuch

To access the "INSTALLER Menu", hold down the
the and
If enabled, enter the "PA2" access PASSWORD (see "PASSWORD" section).
The display will show the first folder in the ADVANCED menu (e.g. folder "rE1"). By pressing
the and
Tun. S.Str out1
Press the key next to the desired folder ("rE2" in the example), the first parameter
set
contained in the folder will be displayed. Select the desired parameter using the
keys. Change the value (shown on the second line) using the
press the or
set
Tun. S.Str out1 aux
NOTE: 1) It is advisable to switch the instrument off then back on again each time
parameters are modified to prevent malfunction of the configuration and/or timer
operations underway.
2) The "INSTALLER Menu" contains all the device parameters, including those
contained in the "USER Menu".

"INSTALLER" Menu

keys, display parameter "PA2" and select it by pressing the
keys you can scroll through all the folders in the "INSTALLER" menu:
5 sec
SET
aux out2 Tun. S.Str out1 aux out2
keys to store the new value.
fnc
SET
out2 Tun. S.Str out1 aux out2
Tun. S.Str
key for more than 5 seconds. Using
set
SET
Tun. S.Str out1 aux out2
Tun. S.Str out1 aux out2
SET
out1 aux out2
Tun. S.Str out1 aux out2
Tun. S.Str out1 aux out2
Tun. S.Str out1 aux out2
and
SET
Tun. S.Str out1 aux out2 Tun. S.Str out1 aux
key.
set
and
keys, then
out2