The Controller Is Inactive During Start-Up/Switch-On (Controller Off) Or When In Standby (Based On The Value Of H08) - Eliwell DR4000 series Handbuch

The auxiliary controller can be activated by key press (parameter H31=4 o H32=4): in this
case the controller must be managed as aux by setting parameters H21(H22)=4.
This function is used to energise the relay if it was de-energised, or vice versa.
The relay state is stored in order to maintain correct operation in the event of a power failure.
NOTE: The controller is INACTIVE during start-up/switch-on (controller OFF) or
when in standby (based on the value of H08)
Televis remote supervision systems can be
connected via:
TTL serial port (use TTL-RS 485 interface
•
module BUS ADAPTER 130 or 150)
direct RS-485 connection on models that
•
feature this provision (DR4022).
To configure the instrument for this
purpose, open the folder identified by the
label "Add" and set dEA and FAA.
AUXILIARY CONTROLLER (AUX)
TELEVIS SYSTEM
IMPORTANT! CHECK THE AVAILABILITY OF MODELS
COMPATIBLE WITH REMOTE SUPERVISION SYSTEMS.
TTL
Personal Computer
+ PCI1110/1120
TelevisCompact
TelevisStation
RS485
-
-