Eliwell DR4000 series Handbuch Seite 7

Password "PA1": access to "User Menu" parameters. The password is disabled by default
(PS1=0). To enable it (PS1≠0): hold down the
scroll through the parameters with
To change the value, press the
value (shown on the second line) using the
keys to store the new value.
fnc
Password "PA2": access to "Installer Menu" parameters. By default the password is disabled
(PS2=0). To enable it (PS2≠0): hold down the
through the "User Menu" parameters with
and scroll though the parameters with
. Scroll through the parameters using
set
To change the value, press the
value (shown on the second line) using the
keys to store the new value.
fnc
The visibility of "PA2" is as follows:
1) if PA1 and PA2≠0: Press and hold down for longer than 5 seconds to display "PA1"
2) Otherwise:
If the entered value is incorrect, the label PA1/PA2 will be displayed once again and the
procedure must be repeated.
PASSWORDS
key. The parameter label will start to blink. Change the
set
key. The parameter label will start to blink. Change the
set
and "PA2". You can then decide whether to access the "User Menu"
parameters (PA1) or the "Installer Menu" parameters (PA2).
Password "PA2" is amongst the level1 parameters. If enabled, it will be
required when accessing the "Installer Menu" parameters; to enter it,
proceed as instructed for password "PA1"
key for at least 5 seconds and then
set
until finding label PS1.
and
and
key for at least 5 seconds and scroll
set
until finding label PA2. Press
and
and until reaching folder diSP then press
and until you find the label PS2.
and
keys, then press the
keys, then press the
or
set
set
or
set