Herunterladen Diese Seite drucken

Putting On The Carrying Strap; Operation; Switching On And Off; Turbo Mode - Parkside PLSA 40-Li A1 Originalbetriebsanleitung

Akku-laubsauger/-bläser
Vorschau ausblenden Andere Handbücher für PLSA 40-Li A1:

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 4
Putting on the carrying
strap
Never wear the carrying
strap diagonally across your
shoulders and chest: only
wear it on one shoulder to
ensure you can detach the
device quickly from your
body in the event of danger.
Pulling the push-fit lock (21) relea-
ses the device quickly from the
carrying strap. To open the push-fit
lock, press the two clamps together.
1. Place the carrying strap (13) on one
shoulder.
2. Adjust the strap length so that the snap
hook is approximately 10 cm below
your hip.
3. Attach the snap hook on the eyelet (12)
to insert the strap.

Operation

Caution! Risk of injury!
Always wear appropriate
protective equipment and
work gloves while working
with the device. Prior to each
use, ensure that the device
is working correctly. Ensu-
re that the device has been
mounted properly.
Stop using the device if the
On/Off button is damaged.
Personal protective equip-
ment and a fully functional
device reduce the risk of inju-
ries and accidents.
After the device has been
switched off, the impeller
continues moving for some
time. Injury hazard caused
by rotating tool!
Observe noise protection rules and
other local regulations.

Switching on and off

The cordless leaf vacuum/blower
may only be used with two batte-
ries of the Parkside X 20 V Team
series.
Before switching the device on,
make sure that it is not touching
any objects. Ensure secure positio-
ning.
1. Press and hold the on/off switch (4) to
start the device.
2. In order to regulate the suction/
blowing power, press the volume con-
trol (3).
+
Pressing
= one level higher
-
Pressing
= one level lower
The 4 LEDs below the charge level
indicator (18) indicate the level of the
suction/blowing power.
3. To switch off, briefly press the on/off
switch (4).

Turbo mode

1. Press and hold the turbo button (3a) to
turn the suction/blowing power to tur-
bo power.
2. Release the turbo button to exit turbo
mode.
GB
IE
35

Werbung

loading