Overview; Technical Data - Parkside PLSA 40-Li A1 Originalbetriebsanleitung

GB IE

Overview

1 Motor housing
2 Handle
3 Volume control
3a Turbo button
4 On/Off switch
5 Rechargeable battery
5a Release button
6 Charger
7 Protective cover, suction aperture
7.1 Marking, protective cover for
suction aperture
7.2 Marking, motor housing
8 Locking button for suction aper-
ture
9 Blowpipe (three-part)
10 Locking button for blowing aper-
ture
11 Additional handle
12 Fastening eyelets for carrying
strap
13 Carrying strap
14 Collection bag carabiner
15 Collection bag
16 Suction pipe (three-part)
17 Angle adjuster for additional
handle
18 Battery charge level indicator
19 Collection bag eyelets
20 Ventilation opening of collection
bag
21 Push-fit lock

Technical data

Cordless leaf
blower/vacuum ........PLSA 40-Li A1
Motor voltage .............. 40 V
Current strength .............................. 16 A
Rated power ........................max. 580 W
Idle speed n ............ 6 000 - 16 300 min
Air speed ........................max. 285 km/h
26
Air suction volume ............ max. 450 m
Shredding rate .................................10:1
Collection bag ................................. 45 l
Protection type................................. IPX0
Weight (without battery)
Blow function .......................... 2,75 kg
Suction function ....................... 3,70 kg
Sound pressure level
(L ) ................... 83,4 dB (A), K
pA
Sound power level (L
guaranteed ............................ 96 dB(A)
measured ............94,7 dB(A); K
Vibration (a
handle ................1,10 m/s
additional handle 1,06 m/s
Noise and vibration values have been de-
termined according to the standards and
regulations mentioned in the declaration of
conformity.
The stated vibration emission value was
measured in accordance with a standard
testing procedure and may be used to com-
pare one power tool to another. The stated
vibration emission value may also be used
for a preliminary exposure assessment.
(2x 20 V)
-1
)
WA
)
h
Warning: The vibration emission
value may differ during actual use
of the power tool from the stated
value depending on the manner in
which the power tool is used.
Try to keep the exposure to vibra-
tions as low as possible. Examples
of measures to reduce vibration
exposure are the wearing of gloves
when using the tool and limiting the
working hours. For this purpose all
parts of the operating cycle have to
be considered (for example, times
when the electric tool is switched
off and times when it is switched on
but running without any load).
/h
3
= 3 dB
pA
= 3 dB
WA
; K= 1,5 m/s
2 2
2 ; K= 1,5 m/s 2