The Three-Piece Blowpipe; Assembling/Dismantling The Three-Piece Suction Pipe; Installing/Removing The Collection Bag - Parkside PLSA 40-Li A1 Originalbetriebsanleitung

GB IE
2. Now push the blowpipe (9) on to the
blowing aperture of the motor housing
(1) until the blowpipe (9) latches into
place.
3. Put the protective cover (7) on the
suction aperture. To do so, place the
protective cover in the opening on the
motor housing (1) so that the marking
on the protective cover (7.1) and the
marking on the motor housing (7.2)
overlap. Turn the protective cover antic-
lockwise until it stops. Push the protec-
tive cover into the motor housing until it
clicks into place.
4. Dismantle the blowpipe (9) by pressing
the locking button (10) and pulling off
the blowpipe.
Assembling/dismantling
the three-piece suction
pipe
Never use the leaf vacuum
with only one suction pipe
section attached. There is a
risk of personal injury!
After the three-part suction
pipe has been assembled, it
must not be divided up again
into three parts!
Pay attention to the correct assem-
bly of the suction pipe (7), otherwi-
se the leaf blower will not start.
1. Open the protective cover (7) of the suc-
tion aperture by pressing the locking of
the suction aperture (8) in the direction
of the suction aperture and pulling out
the protective cover, turning it clockwi-
se until it stops.
remove the protective cover (7).
34
2. Assemble the three suction pipes (16)
3. Place the suction pipe (16) on the suc-
4. Dismantle the suction pipe (16) by pres-
The ventilation opening on the collection bag
(20) serves for an improved air circulation.
1. If necessary, remove the blowpipe
2. Now push the collection bag (15) on
3. Hook the carabiner (14) of the collec-
The additional handle (11) can be locked
in various positions.
1. Press the angle adjuster (17) on the ad-
You can now 2. Adjust the additional handle to the desi-
3. Release the angle adjuster (17).
as illustrated.
When assembling, pay attention to the
guide grooves on the suction pipe parts.
tion aperture, as in fig.
Turn the suction pipe anticlockwise until
it stops. Push the suction pipeinto the
motor housing until it clicks into place.
sing the lock of the suction aperture (8)
in the direction of the suction aperture
and pulling out the blowpipe, turning
it clockwise until it stops. You can now
remove the blowpipe.
Installing/removing the
collection bag
In suction mode the device
must only be operated with
the collection bag mounted.
(
9) (see "Assembling/dismantling

the three-piece blowpipe").

to the blowing aperture of the motor
housing (1) until it latches with the lo-
cking button (10).
tion bag into the eyelets (19) provided
on the motor housing.
ditional handle (11).
red position.
(below).