Atlantic Panama 500 Montageanweisungen Seite 26

Function not available in Cooling mode
To use this function, we advise you to set your appliance to the COMFORT or COMFORT + modes.This function is acti-
vated as standard (activated when the appliance leaves the factory).
Use this function to automatically stop and start the appliance when you air your room, therefore allowing for energy
savings.
When you open the window of the room where your appliance is installed, the
airing is being taken into account and the heating is therefore adjusted.When the window is closed, the symbol stops flas-
hing and the appliance functions normally again.
We advise you not to use the Airing function
door.
Not heating the room whilst you are airing it allows for energy savings. If you forget to turn off the appliance when the
window is open for a long time, the Airing
tically detects when the window is open or closed, therefore not wasting any energy.
The appliance reacts to windows being open or closed, depending
on several variables, in particular:
- desired temperature in the room,
- outside temperature,
- how your installation is setup (location of the appliance compared
with the window).
By detecting the opening and closing of the window, the Airing
function allows you to protect the environment.
Its operating temperature is 7° C, ± 3° C, whilst the room is being aired.When the window is closed, the appliance returns
to its initial operating mode.
In all cases, the appliance starts heating again after 2 hours.The maximum intended airing time is 2 hours.
N.B. If this is not long enough, you can manually stop your appliance from heating (press and hold down
If the screen is not on, press any key to light up the screen.
To deactivate the Airing function,
press 3 times.
To activate it, press
U
SING THE ENERGY SAVING FUNCTIONS
A
IRING FUNCTION
D
in corridors or rooms located close to an entrance door or a garage
prevents the appliance from heating unnecessarily: the appliance automa-
D
ESACTIVATING THIS FUNCTION
A
CTIVATING THIS FUNCTION
once.
ESCRIPTION
The
open or closed disappears from the screen.
The
open or closed appears on the screen.
26
:
symbol flashes to indicate that the
Optimum zone
BOOST
symbol for detecting the window
BOOST
symbol for detecting the window
).