Atlantic Panama 500 Montageanweisungen Seite 18

Use this mode to have the desired room temperature.The fan speed adapts to the heating requirements.
When it is very cold, the heat pump may not be sufficient to maintain the desired Comfort temperature. In this case, the
front heating panel (activated when the appliance leaves the factory) will provide additional heating to maintain the correct
room temperature.
The consumption indicator signal lamps can be used to optimise the setting (see page 27).
If the screen is not on, press any key to light up the screen.
To activate the Comfort mode, press
several times until the mode
selection arrow is on COMFORT
mode .
In Heating mode, the recommended Comfort temperature is 19° C. It can be set between 12.5° C and 28° C.
To change the displayed temperature,
press or .
Wait at least 2 hours for the temperature to stabilise.
If you are not satisfied with the tem-
perature of the room, change the dis-
play by pressing or
H
EATING YOUR ROOM
COMFORT
A
C
HANGING THE DESIRED TEMPERATURE
.
MODE
D
ESCRIPTION
CTIVATING THIS MODE
18
:
BOOST
The mode selection arrow flashes several
seconds, then stays fixed: the setting is confir-
med.
BOOST
The chosen temperature is displayed on the
screen. The fan operates, then the front hea-
ting panel (if you have activated it) to give you
an optimal comfort temperature.
BOOST
The higher the temperature displayed on the
screen, the further the consumption indicator
moves down (orange and red indicators).
The signal lamp lights up when the front
heating panel starts heating.