Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3.5 Fender installation
ALL MOUNTAIN
The fender may be provided with the fork, or purchased
separately.
To install the fender, fi rst insert the support bushing between
the screw and fender (see 6A of Picture 6). Tighten the
screw to the required torque (6±1 Nm) using a 8mm spanner
(see 6B of Picture 6).
There are two types of fenders available, the fi rst can be
installed on ALL MOUNTAIN and the second model can be
installed on 66 e 888.
W
!
ARNING
When the fender is assembled on a 888 fork, the
position of the superior part of the crown must be in
corrispondence to max line on the stanchion.
6A
Picture 6 - Fender installation
3.6 Handlebar clamp installing on all Dual
Crown models
888
To install the handlebar clamp, please carefully follow the
instructions below:
•
Place the lower mounting segment of the handlebar clamp
on the upper crown of the fork (see 7A & 7B of Picture 7).
•
Align the corresponding holes from each of these
components.
60
66
888
6±1 Nm
6B
8 mm
•
Secure the lower mounting segment of the handlebar
clamp to the upper crown of the fork by tightening the
screws to the required torque (6±1 Nm) using a 4mm Allen
key (see 7C of Picture 7).
•
Place the handlebar into the lower mounting segment of
the handlebar clamp, being sure that it is centered (see
7D of Picture 7).
•
Place each upper segment of the handlebar clamp over
the handlebar (see 7E of Picture 7).
•
Align the holes of the upper segment with the corresponding
holes of the lower mounting segment.
•
Secure the handlebar in place by tightening each screw to
the required torque (6±1 Nm) using a 4mm Allen key (see
7F of Picture 7).
For installation of handlebars having different diameters,
"reduction sleeves" may be placed around the handlebar
(between the handlebar and each segment of the handlebar
clamp) to ensure the handlebar is held in place (see 7G of
Picture 7).
Picture 7 - Handlebar clamp installation
7A
7B
6±1 Nm
7C
4 mm
10±1 Nm
7F
5 mm
7G
7E
7D
Quicklinks ausblenden:
Werbung
Kapitel
