Wheel Installation On Ø 32 Forks With A 20 Mm Diameter Through-Hole Axle - Marzocchi Bomber Suspension Benutzerhandbuch

3.4.2 Wheel installation on ø 32 forks with a 20 mm
diameter through-hole axle
ALL MOUNTAIN
For optimum fork performance, please follow the instructions
below when installing the wheel:
• Place the wheel in between each fork.
• Align the center of the wheel with each wheel axle clamp
(see 3A of Picture 3).
• Insert the axle through the wheel axle clamp of the right
fork, through the wheel, and through the wheel axle clamp
of the left fork (see 3A of Picture 3).
• Tighten the axle to the required torque (15±1 Nm) using a
6 mm Allen key to the axle caps (see 3B of Picture 3).
• Check for the proper fork-wheel alignment. To do this,
begin by fully compressing the fork a few times. The wheel
should not make contact with, or come close to any portion
of the fork. Then lift the front of the bicycle and spin the
wheel a few times to verify the correct alignment with the
disk brake. The wheel should not wobble from side to side
or up and down. Check the owner's manual of the brake
system for the proper specifi cations.
• Tighten the screw positioned on each wheel axle clamp to
the required torque (6±1 Nm) using a 4 mm Allen key (see
3C of Picture 3).
Z1
15±1 Nm
6 mm
6±1 Nm
4 mm
3C
Picture 3 - Wheel installation on ø 32 fork with a 20 mm diameter through-hole
axle
3A
3B
3C
6±1 Nm
4 mm
57