Installation; Installing On The Frame - Marzocchi Bomber Suspension Benutzerhandbuch

3.

INSTALLATION

3.1 Installing on the frame

The fork is supplied with an "A-Head Set" steer tube to be
cut according to the frame size the fork is being installed
on. Installing the fork on the bicycle frame is a delicate and
critical operation, and should only be performed by skilled,
trained personnel.
W !
ARNING
Suspension system installation requires specialized
knowledge, tools and experience. General mechanical
aptitude may not be suffi cient to properly install your
suspension system. Please have your suspension
system installed only by an authorized Marzocchi
Suspension Center. Improper installation can result
in failure of your Marzocchi Suspension System, an
accident, personal injury, or death.
The interference of the cylinder on the base and the play
between the cylinder and frame are particularly critical
factors for the safety of the operator. For this reason,
maintenance and installation must be performed exclusively
at authorised technical assistance centres, which have
suitable equipment and specifi c knowledge.
W !
ARNING
On all dual crown MY 2007 MARZOCCHI models, the
lower crown is clamped to the stanchions using bolts. In
this case, please be aware of the following precautions
during installation.
• In case of oversized diameter areas on the stanchions,
the crowns clamping can only be done in the shaded area
shown in Picture 2A.
• In case of reference notches on the stanchions, the lower
part of the lower crown must be positioned above the MIN
notch and below the MAX notch.
• The distance between the infl ated tire and the lower part
of the lower crown, when the fork is at travel's end, must
be at least 4 mm.
• On the dual crown forks the maximum length of the steer
tube between the two crowns (see Picture 2B) must be
smaller than the values (H) shown in Table 1.
54
N
OTE
A protective fi lm to be removed before use protects the
stickers.
A
B
Picture 2 - Dual crown forks installation on the frame: (2A) Crowns fastening,
(2B) Steer tube maximum length between crowns
Model Max length between crowns (H)
888 158mm
Table 1 - Steer tube maximum length between crowns