Wheel Installation On Ø 35 Forks With A 20 Mm Diameter Through-Hole Axle - Marzocchi Bomber Suspension Benutzerhandbuch

3.4.3 Wheel installation on ø 35 forks with a 20 mm
diameter through-hole axle
66
For optimum fork performance, please follow the instructions
below when installing the wheel:
• Place the wheel in between each fork.
• Align the center of the wheel with each wheel axle clamp
(see 4A of Picture 4).
• Insert the axle through the wheel axle clamp of the right
fork, through the wheel, and then screw it into the wheel
axle clamp of the left fork (see 4A of Picture 4).
• Tighten the axle to the required torque (15±1 Nm) using a
6mm Allen key to the caps of the axle (see 4B of Picture
4).
• Check for the proper fork-wheel alignment. To do this,
begin by fully compressing the fork a few times. The wheel
should not make contact with, or come close to any portion
of the fork. Then lift the front of the bicycle and spin the
wheel a few times to verify the correct alignment with the
disk brake. The wheel should not wobble from side to side
or up and down. Check the owner's manual of the brake
system for the proper specifi cations.
• Tighten the screws positioned on each wheel axle clamp
to the required torque (6±1 Nm), with a "1-2-1" sequence,
using a 4mm Allen key (see 4C of Picture 4).
58
888
15±1 Nm
6 mm
6±1 Nm
4 mm
4C
Picture 4 - Wheel installation on ø 35 forks with a 20 mm diameter through
hole axle
4A
4B
4C
6±1 Nm
4 mm