Wheel Installation On A Fork With Qr Quick Release Axle - Marzocchi Bomber Suspension Benutzerhandbuch

3.4.4 Wheel installation on a fork with QR quick release
axle
ALL MOUNTAIN
For optimum fork performance, please follow the instructions
below when installing the wheel:
• Place the wheel in between each fork.
• Align the center of the wheel with each wheel axle clamp
(see 5A of Picture 5).
• Insert the axle through the wheel axle clamp of the right
fork, through the wheel, and then screw it into the wheel
axle clamp of the left fork (see 5A of Picture 5).
• Secure the axle by using the quick release device (see
5B of Picture 5).
• Check for the proper fork-wheel alignment. To do this,
begin by fully compressing the fork a few times. The wheel
should not make contact with, or come close to any portion
of the fork. Then lift the front of the bicycle and spin the
wheel a few times to verify the correct alignment with the
disk brake. The wheel should not wobble from side to side
or up and down. Check the owner's manual of the brake
system for the proper specifi cations.
4X
Picture 5 - Wheel installation on a fork with QR quick release axle
5A
5B
59