Installing The Brake System - Marzocchi Bomber Suspension Benutzerhandbuch

3.2 Installing the brake system

Installing the brake system is a delicate and critical operation
that must be carried out by specialized personnel.
W !
ARNING
Brake system installation
knowledge, tools and experience. General mechanical
aptitude may not be suffi cient to properly install your
brake system. Please have your brake system installed
only by an authorized Marzocchi Service Center.
Improper installation of a disk brake system can
overstress the caliper mountings, which may cause the
caliper mountings to break, resulting in loss of control
of the bicycle, an accident, personal injury, or death. Be
sure that the brake system installation is also performed
in strict compliance with the instructions provided by
the brake system manufacturer.
Use only brake systems that comply with the forks
specifi cations, taking into consideration the contents of the
summarizing tables contained in this manual.
CORSA
2A
2B
Removable setting
(brake disk system sheath supports setting)
Post Mount 6"
Table 2 - Braking system settings
Installation is only possible when the specifi c adapter is supplied by the brake system manufacturer.
1
requires specialized
XC RETRO
V-BRAKE SYSTEM SETTING
BRAKE DISK SYSTEM SETTING
Post Mount 6"
(7" disk installation is also
possible)
1
W !
ARNING
A special thread-lock treatment is applied to the thread
on the bolts (see 2A in Table 2). Bolts that are installed
and later removed lose this thread-lock treatment, and
therefore can never be used again.
W !
ARNING
Make sure, before every ride, that the brake cable of the
disk brake system is correctly connected to the proper
mounting (see 2B & 2C in Table 2).
W !
ARNING
The brake cable must never touch the crown and
stanchions.
W !
ARNING
Before installing a Post Mount braking system, check
that the protection fi lm has been removed from the
brake caliper.
ALL MOUNTAIN - 4X
66 - 888
2C
(brake disk system sheath supports setting)
Post Mount 6"
(8" disk installation is also possible)
Z1
DIRT JUMPER
No
XC INTL STD 6"
1
55