Filling Sausages - Vitek VT-3600 BW Betriebsanweisung

ENGLISH
• Let the meat grinder cool down for approximately
50-60 minutes before switching it on again.
• Plug the meat grinder into the mains, switch it on,
if the meat grinder cannot be switched on, this may
mean that it is otherwise damaged. In this case con-
tact the authorized service center for meat grinder
repair.

FILLING SAUSAGES

1. Prepare minced meat.
2. Install the meat grinder head (3) to the attaching
point (4), and turn it counterclockwise until bumping.
3. Insert the screw (12) into the meat grinder head
body (3), set the crossed blade (13), take the grate
(15 for fine chopping) and set it above the blade,
matching the ledges on the grate with the grooves on
the meat grinder head body (3), install the sausage
attachment (17) and tighten the nut (16) (pic. 7).
4. Install the food tray (2).
5. Put the minced meat on the food tray (2).
6. Use natural sausage casing, putting it preliminarily
into a bowl with warm water for 10 minutes (pic. 8).
7. Pull softened casing on the attachment (17) and
make a knot on the tip.
8. Insert the power plug into the mains socket, the but-
ton (11) « » illumination will light up.
9. Switch the unit on by pressing the button (11) «
10. Use the pusher (1) to feed the minced meat, as the
casing is filled up, slide it off the attachment (17)
as necessary, and wet the casing if it becomes dry.
11. After you finish operating, switch the meat grinder
off, pressing the button (11) «
after that you can disassemble it.
12. To remove the meat grinder head press the lock
button (5), turn the meat grinder head (3) clockwise
and remove it.
13. Unscrew the nut (16) and disassemble the meat
grinder head.
USING "KEBBE" ATTACHMENTS
Kebbe is a traditional Middle East dish cooked of lamb
meat, wheat flour and spices cut together for getting
a base for hollow rolls. Rolls are filled and deep fried.
You can make different delicacies trying various fillings.
1. Prepare the casing base.
2. Install the meat grinder head (3) to the attaching
point (4), and turn it counterclockwise until bumping.
3. Insert the screw (12) into the meat grinder head
body (3), install "kebbe" attachments (18, 19) on the
screw (12), make sure that the ledges on the attach-
ment (19) match the grooves on the meat grinder
head body (3) and tighten the nut (16) slightly. (pic.
9, 10).
4. Install the food tray (2).
5. Put the prepared casing base on the food tray (2).
6. Insert the power plug into the mains socket, the but-
ton (11) « » illumination will light up.
7. Switch the unit on by pressing the button (11) «
8. Use the pusher (1) to supply the base for casing.
».
», unplug it and only
».
6
9. Cut the rolls of the required length.
10. After you finish operating, switch the meat grinder
off, pressing the button (11) «
after that you can disassemble it.
11. To remove the meat grinder head press the lock
button (5), turn the meat grinder head (3) clockwise
and remove it.
12. Unscrew the nut (16) and disassemble the meat
grinder head.
RECIPE
(Filling)
Lamb
Olive oil
Onion (shred)
Spice
Salt
Flour
• Mince the lamb meat once or twice.
• Fry onion in oil till it gets gold color, and then add
minced lamb meat, spice, salt and flour.
(Casing)
Lean meat
Flour
Spice
Nutmeg
Ground chilly pepper
Pepper
• Mince the meat twice or thrice, mince a nutmeg,
and mix all the components.
• More meat and less flour in a casing provide better
consistency and taste of the prepared dish.
• Fill the rolls, clamp at edges, and shape as you wish.
• Deep fry the rolls.
MEAT GRINDER CARE
• After you finish operating, switch the meat grinder
off, pressing the button (11) «
after that you can disassemble it.
• Unscrew the nut (16), remove the installed attach-
ments (17, 18, 19), the grates (14 or 15) and the
blade (13) from the screw (12) (pic. 11).
• Press the lock button (5), turn the meat grinder
head clockwise and remove it (pic. 12).
• Remove the screw (12) from the meat grinder head (3).
• Remove the remains of the products from the screw
(12).
• Wash all the used parts of the meat grinder with
warm soapy water and neutral detergent, then rinse
and dry thoroughly before assembling.
», unplug it and only
100 g
1½ table spoon
1½ table spoon
to taste
¼ tea spoon
1½ table spoon
450g
150-200 g
to taste
1 pc.
to taste
to taste
», unplug it and only