General Description; Scope Of Delivery; Overview; Technical Data - Parkside PHS 160 C4 Originalbetriebsanleitung

General Description

The illustration of the principal
functioning parts can be found
on the front and back foldout
pages.

Scope of delivery

Carefully unpack the trimmer and check
that it is complete. Dispose of the packag-
ing material correctly.
• Device
• Dust box
• External dust extraction adaptor
• Sandpaper P 120*
• Translation of the original instructions
*P = Grain size

Overview

1 On/off switch
2 Hand rest
3 Fixing lever
4 Dust box
5 Opening lever for dust box
6 Dust box vent
7 External dust extraction
adaptor
8 Dust extraction connector
9 Fastener for dust box
10 Air vent
11 Air inlet
12 Sanding plate
13 Mains plug
14 Extraction hole
15 Sandpaper

Technical Data

Detail sander .................................. PHS 160 C4
Rated input voltage
Power input ................................ 160 W
Idling speed (n) .....................13000 min
Oscillation rate .....................26000 min
Weight .....................................1,25 kg
Protection class .................................
Protection category ......................... IP 20
Sound pressure level
(L ) .......................... 86 dB(A);
pA
Sound power level (L
measured .................97 dB(A); K
Vibration
(a ) ................. 11,8 m/s
h
Technical and optical changes can be
carried out in the course of further develop-
ment without notice. All dimensions, refer-
ences and information of this instruction
manual are therefore without guarantee.
Legal claims, which are made on the basis
of the instruction manual, cannot thus be
considered as valid.
The stated vibration emission value was
measured in accordance with a standard
testing procedure and may be used to com-
pare one power tool to another.
The stated vibration emission value may
also be used for a preliminary exposure
assessment.
Warning: The vibration emission
value may differ during actual use
of the power tool from the stated
value depending on the manner in
which the power tool is used.
Safety precautions aimed at protect-
ing the user should be based on
estimated exposure under actual
usage conditions (all parts of the op-
...........230 V~, 50 Hz
K = 3 dB
pA
)
WA
= 3 dB
WA
; K= 1,5 m/s
2
G B
-1
-1
II
2
5