Sent Data - Weatherdock easyTRX2S Handbuch

Page 87 of 131
th
In this picture above the reverse power is only a 10 of the forward
power which means that most of the signal is fully send to the
antenna.
If not you can see an error with "VSWR exceeds limit".
In this case the antenna is not connected and most of the power is
reflected.
Please check your connectors and wires if this failure appears.
Also through-deck mounting sockets could effect this error if
the quality is not good here.
The LED display of an easyTRX2S device is also displayed in the
software.
If the check routine of the easyTRX2S device noticed any fault, or if
there is a warning, a short notice will be given in the respective tables.
The easyTRX2S executes a self-test every 30 seconds and displays the
result. As a result each error or warning report has got a countdown of
1 minute. This means the report disappears from the table if the error
or warning message is not received once again within 1 minute. Thus
the error or warning no longer exists.

6.3 Sent data

The tab "Sent Data" gives information about the last AIS data sent by
the easyTRX2S Transceiver.
This is on the one hand the "Position Report" (AIS-Message No. 18),
which transmits MMSI, position, speed and bearing. Below you can see
how much time elapsed since the latest transmission. This can be up to
3 minutes, if your speed is less than 2 kn or 30 seconds if your speed is
faster. On the other hand there is the "Static Data Report" (AIS-
Weatherdock AG Sigmundstraße 180 D-90431 Nürnberg
Tel.: +49 911 376638 30 www.weatherdock.de