Weatherdock easyTRX2S Handbuch Seite 84

Page 84 of 131
only be entered once. Please contact your service partner if the MMSI
was entered wrongly or if you are required to enter a new and
different MMSI. They can reset the MMSI.
To program your ship-specific data connect the easyTRX2S device with
your PC by means of the USB cable. In addition ensure 12VDC power
supply.
Initially select the COM port the easyTRX2S device is connected to and
click on „connect".
Wait until you get the green field filled with "Connected" before you
enter your ship data
The NMEA port of the Class B Transponder is preset to 38400 baud by
default. You can change the baud rate with the RS422 (NMEA0183)
software if you have a chart plotter whose NMEA input allows only
4800 baud. Please us the grey and yellow cable for this feature.
Another option is the output of GPS information. The devices of the
esasyTRX2S product line can output the GPS data of the integrated
receiver via NMEA or USB port. This is useful if your chart plotter does
not have its own GPS. A minimum output of GPS data (RMC, GGA) is
set as a standard feature by default. It is possible to dismiss the output
entirely or to set it to maximum information (RMC, GGA, GSV, VTG,
GLL and GSA), if the chart plotter requires.
Note (valid for –WiFi units):
The switchable output port is also used internally for our WiFi module.
If you want to change it to 4800 baud you cannot use the full function
of WiFi. In this case the unit can send data to your phone/tablet/PC.
The other way, send commands e.g. asking MMSI number by our
mobile application easyTRX2S" Programming Tool available for iOS
and Android, won´t work.
Search for "easyTRX2S" within Play/Appstore of Android/iOs
Weatherdock AG Sigmundstraße 180 D-90431 Nürnberg
Tel.: +49 911 376638 30 www.weatherdock.de