Note: Please remember energy stored in the
rechargeable batteries power both the LED light and
the charging station . Using it as a charger therefore
reduces the operating time and brightness in lighting
mode .
Using as a LED light
Fully charge the product as described in the
section "Charging the product" .
The product can be operated in 4 different modes .
Select these by repeatedly pressing the ON/OFF
switch 3 .
ON/OFF switch Mode
Press 1x:
The white light lights up at
maximum mode .
Press 2x:
The white light lights up at
Eco mode .
Press 3x:
SOS blinking (white light)
Press 4x:
Red light blinking
Press 5x:
Switch off the light
Using as a charger
When used with the USB cable 12 , the product may
be used to charge small electronics devices with
micro-USB socket for charging (e .g . mobiles or digital
cameras) .
Please note, the charging current the device
requires may not exceed 2 A . Carefully read
the instructions for use of the device you wish to
charge .
20 GB/IE
ATTENTION! The flashing
red light can have adverse
effects on the health of
predisposed individuals!
The flashing light is not
suitable as a traffic warning
light .
ATTENTION! Charging a device which requires a
higher charging current may cause a defect in both
devices .
Also note, the battery of the device you wish to
charge must have a significantly smaller capacity
than the total capacities of the rechargeable
batteries inside the product (6000 mAh) .
Otherwise charging may not complete .
Open the protective cap 7 .
Insert the USB plug of the USB cable 12 into the
USB output socket 9 .
Insert the micro-USB plug of the USB cable into the
small electronic devices you wish to charge . The
green charging indicator 5 lights up, indicating
the battery capacity .
Remove the USB cable 12 as soon as charging is
complete .
Close the protective cap 7 .
Maintenance and cleaning
The product requires no maintenance . The LEDs cannot
be replaced .
Switch off the product and disconnect the power
adaptor from socket or unplug the car charger
adaptor 11 from the 12 V socket before cleaning .
Close the protective cap on the micro-USB input
socket and USB output socket .
Never immerse the product in water or other
liquids .
Never use caustic cleaners .
Regularly clean the product with a dry, lint-free
cloth . Use a slightly moist cloth to remove any
stubborn dirt .