Using As A Led Light; Using As A Charger - Parkside PBSL 5000 A1 Bedienungs- Und Sicherheitshinweise

˜ Using as a LED light
Fully charge the product as described in the
section "Charging the product" .
The product can be operated in 3 different
modes . Select these by repeatedly pressing
the ON/OFF switch
ON/OFF Mode
switch
Press 1x: 2 white lights light up .
Press 2x: 1 white light lights up .
Press 3x: 1 white light lights up .
Press 4x: Switch off the light .
˜ Using as a charger
When used with the USB cable
may be used to charge small electronics devices
with USB socket (Type C) for charging (e .g .
mobiles or digital cameras) .
Please note, the charging current the device
requires may not exceed 2 A . Carefully read
the instructions for use of the device you wish
to charge .
ATTENTION! Charging a device which requires
a higher charging current may cause a defect in
both devices .
.
2 ] [
, the product
10 ] [
The battery of the device you wish to charge
must have a significantly smaller capacity
than the total capacities of the rechargeable
batteries inside the product (5000 mAh) .
Otherwise charging may not complete .
Open the protective cap
Insert the USB plug of the USB cable
the USB output socket
Insert the USB plug of the USB cable
into the small electronic devices you wish to
charge . The red charging indicator
up, indicating the battery capacity .
Remove the USB cable
charging is complete .
Close the protective cap
˜ Maintenance and cleaning
The product requires no maintenance . The LEDs
cannot be replaced .
Before cleaning:
Switch off the product .
–
Disconnect the USB cable
–
socket .
Close the protective cap
–
input socket and USB output socket
8 ] [
Never immerse the product in water or other
liquids .
Never use caustic cleaners .
Regularly clean the product with a dry, lint-
free cloth . Use a slightly moist cloth to remove
any stubborn dirt .
.
[ 7 ]
into
[ 10 ]
.
[ 9 ]
10 ] [
lights
6 ] [
as soon as
[ 10 ]
.
[ 7 ]
from the USB
[ 10 ]
on the USB
[ 7 ]
.
9 ] [
GB 11