Setting Up The Tripod; Setting The Tripod Height; Assembling The Work Light On The Tripod; Disassembling The Work Light - Parkside FCL-80121 Montage-, Bedienungs- Und Sicherheitshinweise

Setting up the tripod

Loosen the clamping nut
anticlockwise (see Fig. E).
Catch the tripod element where the legs are con-
nected at the same height as the clamping nut
and press it downwards so that the legs unfold.
When the tripod element cannot be pushed
down any further, and the legs have fully folded
out, re-tighten by turning the clamping nut
clockwise (see Fig. F).

Setting the tripod height

(see Fig. G)
Loosen the height adjuster
anticlockwise.
Set the tripod at the desired height by pull-
9
ing the rod elements upwards or pushing them
downwards.
Tighten the height adjuster
wise to fix the tripod
Assembling the work
light on the tripod
Note: To assemble the work light on the tripod
you must firstly assemble the spotlights
handle piece on the mounting bracket
1
ceed as described in the chapter "Assembling the
spotlights and handle piece on the mounting bracket".
Place the mounting bracket
and handle piece
2
The handle piece
1
direction of the retaining plates on the clamp
as otherwise, it cannot be fixed. Also ensure that
you place the holes on the underside of the
mounting bracket
5
(see Fig. HI and HII).
7
Close the retaining plate of the clamp
(see Fig. HIII).
Flip the clip of the clamp upwards, so that it
catches in the retaining plate (see Fig. HIV).
Press the locking handle of the clamp
wards to fix the mounting bracket
by turning it
11
11
11
by turning it
8
by turning it clock-
8
at the desired height.
9
and the
2
. Pro-
5
(with spotlights
5
) on the open clamp
1 7
must be orientated in the
7
on the pins of the clamp
7
down-
7
(see Fig. HV).
5

Disassembling the work light

SHOCK! Remove the mains plug from the
mains socket before disassembly.
CAUTION! RISK OF BURNS DUE TO
HOT SURFACES! Allow the light to cool
down fully before disassembling it.
To disassemble the individual elements, proceed
in the reverse order as described in the respective
chapters.

Operation

Using the light (see Fig. I)
Completely unwind the mains cable
Connect the mains plug to the mains socket.
You can switch the light of any of the spotlights
on and off by press the ON / OFF switch
2
on the back.
Position I: 50 % light, 2250 Lumen (both
spotlights together 4500 Lumen)
Position II: 100 % light, 4500 Lumen (both
spotlights together 9000 Lumen)
Position 0: Off
Loosen the wing bolt
into the desired position. Re-tighten the wing bolt
9
to fix the spotlight
3

Using the socket

Before using the socket
. maximum nominal load of 3580 W is NOT
exceeded by the connect device.
, The socket
14
ways active when the mains plug of the product
is in the wall socket.
To use the socket
light, flip the socket cover up and connect the
desired device.
DANGER OF ELECTRIC
15
to tilt the spotlight
3
in the desired position.
2
ensure that the
14
on the back of the spotlight is al-
on the back of the spot-
14
.
16
2
GB/IE 17