Using As A Led Light; Using As A Charger; Maintenance And Cleaning - Parkside PAAL 6000 B2 Bedienungs- Und Sicherheitshinweise

˜ Using as a LED light
Fully charge the product as described in the
section "Charging the product" .
The product can be operated in 4 different
modes . Select these by repeatedly pressing
the ON/OFF switch
ON/OFF Mode
switch
Press 1x: The white light lights up at maximum
mode .
Press 2x: The white light lights up at
Eco mode .
Press 3x: SOS blinking (white light)
Press 4x: Red light blinking
ATTENTION! The flashing red
light can have adverse effects
on the health of predisposed
individuals!
The flashing light is not suitable
as a traffic warning light .
Press 5x: Switch off the light .
˜ Using as a charger
When used with the USB cable
may be used to charge small electronics devices
with USB socket (type C) for charging (e .g .
mobiles or digital cameras) .
Please note, the charging current the device
requires may not exceed 2 A . Carefully read
the instructions for use of the device you wish
to charge .
12 GB
.
2 ] [
, the product
13 ] [
ATTENTION! Charging a device which requires
a higher charging current may cause a defect in
both devices .
Also note, the battery of the device you wish
to charge must have a significantly smaller
capacity than the total capacities of the
rechargeable batteries inside the product
(6000 mAh) . Otherwise charging may not
complete .
Open the protective cap
Insert the USB plug of the USB cable
the USB output socket
Insert the USB plug (type C) of the USB cable
into the small electronic devices you wish
[ 13 ]
to charge . The green charging indicator
lights up, indicating the battery capacity .
Remove the USB cable
charging is complete .
Close the protective cap
˜ Maintenance and cleaning
The product requires no maintenance . The LEDs
cannot be replaced .
Switch off the product and disconnect the
power adaptor from socket or unplug the car
charger adaptor
12 ] [
before cleaning .
Close the protective cap
socket and USB output socket
[ 9 ]
Never immerse the product in water or other
liquids .
Never use caustic cleaners .
Regularly clean the product with a dry, lint-
free cloth . Use a slightly moist cloth to remove
any stubborn dirt .
.
8 ] [
into
[ 13 ]
.
[ 10 ]
[ 6 ]
as soon as
13 ] [
.
[ 8 ]
from the 12 V socket
on the USB input
[ 8 ]
.
10 ] [