Switching On And Off; Working Instructions; Swivelling The Battery-Powered Led Work Light; Magnet - Parkside PLLA 12 C3 Originalbetriebsanleitung

GB IE
• The LEDs indicate the
battery's charge level, when
the device is in operation.
red-yellow-green =>
Battery fully charged
red and yellow =>
Battery half charged
red =>
Battery needs to be charged
Switching ON and
OFF
1. To start, press the on/off
switch (6). The LED lamp
illuminates with maximum
brightness.
2. To reduce the brightness,
hold down the on/off switch
(6) for about 3 seconds.
To return to maximum
brightness, press the on/off
switch (6) again for about 3
seconds.
3. To switch off, briefly press the
on/off switch (6).
During breaks in work,
the device can be hung
from a belt, using the
integral belt clip (1).
22

Working instructions

Do not stare into the bat-
tery-powered LED work
light when it is switched
on
Swivelling the
battery-powered
LED work light
The LED light (4) can be folded
out from the device housing (8)
and adjusted to 8 positions.

Magnet

Take care, because
sliding the battery-
powered LED work light
can cause the magnetic
surface to become scrat-
ched!
Using the magnets (9), you
can fix the battery-powered
LED work lamp to magnetic
surfaces
The LED light (4) can be folded
out from the device housing (8)
and adjusted to 8 positions.
See illustration .