Activation Of Blower (Air Compressor); Underwater Spotlight; Utility Functions; Control Panel Lock - Jacuzzi Profile Montageanweisung

I

ACTIVATION OF BLOWER (air compressor)

Press the "Blower"
The blower can be activated either in conjunction with, or
separately from, the hydromassage pumps. When the system is
started, however, the blower is always off, as are the hydro-
massage pumps.
The blower stays on for 20 minutes. It can be shut off before
that by pressing the key again.
If you want to use the blowers for aroma therapy, insert
fume cartridge in the compartment located under the cover. Once
this cartridge is finished, it can be replaced by unscrewing the plug
and replacing it with a new one (cartridges are available from au-
thorised dealers and technical service centres).
NOTE: Replace used cartridges when the blower is off.
NOTES
- If the level of water in the compensation tanks is not correct,
the blower is prevented from starting to protect it (also see the
chapter on checking operation and first start-up).
- Activating the blower and the hydromassage pumps at the
same time will turn heater off, if it is on.
- When the blower is started, the filtering pump is also turned
on, if it was not already. It will remain on for 10 minutes after
the function is turned off.
key to start the air compressor.
I

UNDERWATER SPOTLIGHT

The digital LED lighting system can be turned on using the key
on the control panel.
Press the "Light"
the wall of the tub.
The spotlight will stay on for two hours, but it can be turned
off before that by pressing the key again. Refer to the user's
manual for the operation of the various sequences of colours.
NOTE: when you turn on the spotlight, the filtering pump is al-
the per- so turned on, as there is probably someone in the tub. It stays
on for 10 minutes after the spotlight is turned off.

Utility functions

I

CONTROL PANEL LOCK

There are two modes for this function:
- Partial lock: this makes it impossible to programme the filtering
cycle. You also cannot activate the energy savings mode (Econo)
and rapid filtering ("Instant Clear").
All other control panel keys remain active.
- Total lock: this mode prevents operation.

Partial lock

To activate this function:
Press and hold the key "Econo"
symbol for the locked panel will flash on the display (
tinue holding the key until the message "LocP" appears and the
symbol stays on steady, which indicates that the lock has been
activated.
If you press a key whose use is not permitted, the display will
show the message "LocP" for five seconds.

Total lock

To activate this function:
Press and hold the key "Econo"
locked panel will flash on the display (
the key even after the message "LocP" appears, until the mes-
sage "LocF" appears. The function is now active.
If you press any key, the display will show the message
"LocF" for 5 seconds.
33
key to turn on the spotlight located on
for a few seconds. The
. The symbol for the
). Continue holding
). Con-