Operation; Measures At The End Of Operation - HUPFER SGR Betriebsanleitung

Operation

Operation
5.2 Operation
Place the trays on the belt uniformly to ensure a smooth transport.
The conveyor system keeps on running automatically. If required you can manually influence the conveying
process by means of the operating console.
Switching on:
§
Set the main switch (1) on the SGR from the switch position 0 to the switch position 1. The system is
switched on and ready for operation.
§
Set the belt speed on the potentiometer (4) to the value 1-2.
§
Press the green start button (3) or the foot switch (option) to start the conveyor system.
Switching off / stop:
§
The belt of the conveyor system will automatically stop moving, if the light curtain has been
interrupted.
§
Press the red stop button (2) or the foot switch (option) to stop the conveyor system if required.
§
Set the main switch (1) on the SGR from the switch position 1 to the switch position 0. As a result, the
conveyor system will switch off.
5.3

Measures at the End of Operation

ATTENTION
To take the conveying device out of operation, proceed as follows:
§
Do not put further trays onto the conveying device and make sure that the conveyor belt is cleared up.
§
Switch off the conveyor system on the control panel.
§
Disconnect the conveyor system from the mains with the main switch.
4330053_A5
Rotating machine parts
There is a risk of crush injuries and injuries caused by being pulled into the
appliance.
Wait until the belt comes to a standstill.
Chapter 5
Page 23
Belt Conveyor System
SGR | SPV