Measures For Putting The Appliance Into Operation; Decommissioning, Storage And Recycling - HUPFER SGR Betriebsanleitung

Transport, Assembly, Putting into Operation and Decommissioning

Decommissioning, Storage and Recycling

4.3.2

Measures for putting the appliance into operation

There should be no loads on the system while putting it into operation.
Check the following while putting the conveyor system into operation to ensure the safety:
§
Pay attention to unusual noises.
§
Check whether the belt is moving straight.
§
Conveyor system, light curtain and limit switch must be free of foreign objects.
§
Unlock the Emergency stop button.
§
Set the potentiometer.
In case of proper functionality you can put the conveyor system into operation.
4.4 Decommissioning, Storage and Recycling
To take the conveyor system out of operation, proceed as follows:
§
Take the conveyor system out of operation and secure it against unauthorised reactivation.
§
Switch off the conveyor system and the motor at the mains.
The conveyor system must be temporarily stored in a dry and frost-free environment. The conveyor system
must be kept covered with a suitable covering material to be protected against dust ingress.
The appliance kept in the storage location must be checked for damages and corrosion every 6 months.
NOTE
Before the appliance is taken back into operation it must be clean and dry.
To dismantle the conveyor system, proceed as follows:
§
Remove the belt.
§
Dismantle the control and operating elements.
§
Unscrew the segments of the conveyor system beginning with first one at the beginning of the belt.
§
Dismantle all segments up to the end of the belt system.
§
Clean the machine parts to remove used lubricants.
If the conveyor system is required to be recycled, all the operating and auxiliary materials must be disposed
in an environmentally compatible manner. The recyclable materials must be properly separated and
disposed in an environmentally compatible manner according to the local Waste Disposal Regulations. In
any case, the local bodies responsible for disposal are to be involved for this purpose. Separate the reusable
materials of the appliance (casters and plastic parts) before disposing or send the appliance to a recycling
centre. Dispose the electronics at corresponding collection centres.
We offer our customers to dispose their waste appliances. Please contact us or one of our distribution
partners.
Packaging and packing material can be sent to the recycling centre by indicating the waste disposal contract
number. If you do not have the valid waste disposal contract number, you can ask for it at
Service.
4330053_A5
Condensed water formation
Ensure that there is sufficient ventilation and no large temperature fluctuations
in the storage location to avoid condensed water formation.
Chapter 4
Page 21
®
HUPFER -
Belt Conveyor System
SGR | SPV