Safety Instructions; Introduction; Warning Symbols Used; Safety Instructions For Appliance Safety - HUPFER SGR Betriebsanleitung

Chapter 2
Page 8
2

Safety Instructions

2.1

Introduction

The chapter on safety instructions describes the risks associated with the appliance in terms of product
liability (according to the EU Machinery Directive).
The safety instructions should warn of hazards and help to avoid damages to persons, the environment and
property. Please make sure that you have read and understood all the safety instructions given in this
chapter.
You must comply with the respectively valid national and international Safety at Work Regulations. The
manager is responsible for the valid regulations he/she has to provide. He/she must acquaint himself/herself
and the operator with the new regulations.
2.2

Warning Symbols Used

Symbols are used in these operating instructions to point out the dangers that can occur while operating or
cleaning the appliance. In both cases, the symbol provides information on the type and circumstances of
danger.
The following symbols can be used:
2.3

Safety Instructions for Appliance Safety

Safe operation of the appliance depends on appropriate and thorough use. Negligent handling of the
appliance can lead to danger to life and limb of the user and / or third parties as well as hazards to the
appliance itself and the other operator's property.
The following points are to be observed to ensure the appliance safety:
§
The appliance may only be operated as intended, when it is in perfect condition with regards to
technical standards, with awareness of safety and hazards and in accordance with the operating
instructions.
§
All the operating and actuating elements must be in a perfect and functionally reliable condition with
regards to technical standards.
§
Only operate the conveyor system when all the safety devices or emergency stop devices are
available and function properly. There should be easy access to the emergency stop button. Do not
remove safety devices.
§
Comply with the safety instructions and hazard warnings on the conveyor system and make sure they
are easy-to-read.
§
The appliance must be checked for external visible damages and defects whenever it is put into
operation. In case of damages, inform immediately the competent bodies and switch off the conveyor
system.
§
Modifications or retrofits of the equipment are only permitted in consultation with the manufacturer
and on receipt of his written agreement.
§
Stationary conveyor systems are designed for permanent installation.
Belt Conveyor System
SGR | SPV
General hazardous area
Hazardous electrical voltage
Risk of pulling in
Safety Instructions
Introduction
4330053_A5