Safety Instructions For Troubleshooting; Notes On Specific Hazards - HUPFER SGR Betriebsanleitung

Chapter 2
Page 10
§
Observe the valid product safety regulations when handling oils, greases and other chemical
substances.
§
Lubricants must be compatible with foodstuffs like, for example, edible oil.
§
Carry out all the checks and inspections of the appliance on a regular basis. Remedy immediately
deficiencies, such as loose screw connections or melted cables.
§
Fit the dismantled safety devices back to the appliance and check them for proper functionality after
completing maintenance and repair work.
§
For reasons of hygiene the cleaning instructions shall be strictly observed.
2.6

Safety Instructions for Troubleshooting

The following points shall be observed when carrying out any trouble shooting operations:
§
The local applicable Accident Prevention Regulations must be observed.
§
Take the conveyor system out of operation, switch it off and secure against unauthorised reactivation
before performing maintaining or troubleshooting operations. When operating on the electrical
installation, the appliance is to be switched off at the mains and secured against reactivation.
§
Observe the valid product safety regulations when handling oils, greases and other chemical
substances.
§
Wear suitable protective clothing when carrying out any repair work.
§
Only authorised specialists may perform all repair work.
§
Tighten the loosen screw connections and fit the safety devices back to the appliance if dismantled
and check them for proper functionality after completing the repair work.
§
Defective components should only be replaced with original parts.
2.7

Notes on Specific Hazards

Electrical energy
§
All work on the electrical installations should only be carried out by a certified electrician or by
authorised specialists under supervision and monitoring of a certified electrician according to the
certain electro-technical regulations.
§
The appliances that inspection, maintenance and troubleshooting work is performed on must be
switched voltage free on and secured against reactivation, when the voltage is not required for this
kind of work. This must only be carried out by a certified electrician.
Belt Conveyor System
SGR | SPV
Safety Instructions
Safety Instructions for Troubleshooting
4330053_A5