View Of The Food Distribution Belt System; Standard Equipment; Equipment And Optional Accessories - HUPFER SGR Betriebsanleitung

Description and Technical Data
Appliance Description
3.4.2

View of the food distribution belt system

Figure 2
1 Beginning of the belt
3 Belt
5 Belt system leg
7 Control panel
9 Limit switch
11 Intermediate part
13 Deflection element
3.4.3

Standard equipment

The standard design of the conveyor system includes a dirt scraper and a cleaning drawer that are fitted at
the end of the belt underneath the operating elements.
The dirt scraper is necessary to clean the belt regularly. It is fitted so that the clearance between the belt and
dirt scraper is sufficient to remove leftovers and impurities form the belt without damaging it.
Finally, leftovers and impurities wiped off by the scrapper fall down into the cleaning drawer.
3.4.4

Equipment and optional accessories

You can install and fit the conveyor system with optional accessories in various ways:
§
Types of installation (SGR and SPV):
The standing alone model of the conveyor system is mounted on stands. A combination of wall and
base installation is possible.
A mobile model includes 2 swivel casters per belt system leg. All the swivel casters have total brakes
for safety reason.
§
Plastic shelves in the base (SGR and SPV)
The plastic shelves are to be used as store place in the base. Put the elements on to the long rails in
the base of the conveyor system. The shelves can be used even at maximum load (up to 10kg/m) for
longer time at the temperature between -22°F and 158°F (-30°C and +70°C).
§
Limit box with limit rocker switch (SGR and SPV)
The limit rocker switch is fitted in the limit box of the frame surface at the end of the belt. In case of
4330053_A5
View of the appliance SPV
2
4
6
8
10
12
Connector with conveyor roller
Control
Cleaning drawer with scraper
End of the belt
Drive component with drive station
Conveyor system
Chapter 3
Page 13
Belt Conveyor System
SGR | SPV