Husqvarna TE 250 2008-I.E. Merkmale, Gebrauch, Wartung Seite 150

Cap7_GB 9-07-2007 16:27
HANDLEBAR POSITION AND HEIGHT CHANGE
The handlebar position (a) and height (b) can be changed for
better suiting Your driving requirements. To effect these opera-
tions, remove the upper screw (3), upper clamp (1), lower
screw (4) then lower clamp (2).
48
Pagina 48
a) Handlebar position change
Turn the lower clamp (2) 180° to move forward or backward
(10mm- 0.04in.) the handlebar position with respect to the
original setup.
b) Handlebar height change
Remove the lower spacer (A) then replace the screw (4) with a
new one of L=65 mm (2.56 in.) height.
Once these operations are completed, tighten the screws (3) to
2,75-3,05 kgm (27-30 Nm; 19.9-22 Lb/fts) and the screws (4)
to 2,0-2,2 kgm (19,6-21,6 Nm; 14.5-15.9 Lb/fts).