Husqvarna TE 250 2008-I.E. Merkmale, Gebrauch, Wartung Seite 148

Cap7_GB 9-07-2007 16:27
The standard calibrations and the adjustment procedures are
shown on the next pages. The springs available upon request,
together with the preload spacers, are shown on pages 95, 96,
97, 98.
ADJUSTING THE COMPRESSION FORK
a) Compression (Lower register)
Standard calibration: -15 clicks (TC-TXC);
Standard calibration: -12 clicks (TE-SMR).
Remove plug (B) and turn register (A) clockwise until the posi-
tion of fully closed is reached then, turn back by the men-
tioned clicks.To obtain a smoother braking action, turn the reg-
ister anticlockwise. Reverse the operation in order to obtain a
harder action.
a)
A
b)
C
46
Pagina 46
b) EXTENSION (upper register)
Standard calibration: - 15 clicks (TC-TXC);
Standard calibration: - 12 clicks (TE-SMR).
To reset standard calibration turn register (C) clockwise to
reach the position of fully closed; then, turn back by the men-
tioned clicks. To obtain a smoother braking action, turn the
register anticlockwise. Reverse the operation in order to obtain
a harder action.
TE-SMR
B
TE-SMR
TE-SMR
c) AIR VENT (to carry out after each competition, or monthly).
TE-SMR: set the motorcycle on a central stand and release the
fork fully and loosen the air vent valve (D). Once this opera-
tion is over, tighten the valve.
TXC-TC: Place the vehicle on a central stand, pull the fork all
out, then remove the cap (E) and press the valve with a tip. Fit
the cap back in.
WARNING!
NEVER loosen the screw (F).
WARNING: Never force the adjusting screws beyond
the maximum opening and closure positions.
E
C
TC-TXC
TC-TXC
D
C
C
F